Cor-A-Vent Product Guide

07723-4 ** NOTE TO SPECIFIER ** Delete 1 of the following 2 paragraphs. 4. Color: White. Q. Soffit Vents: Cor-A-Vent RS-400 Raft-A-Vent. 1. Net free area: 10 sq in per lin ft (21168 sq mm/m). 2. Dimensions: 1 inch (25 mm) high by 22.5 inches (570 mm) long by 1-1/2 inch (38 mm) wide. 3. Color: Black. 4. Color: White. ** NOTE TO SPECIFIER ** Delete 1 of the following 2 paragraphs. R. Soffit Vents: IN-Vent (Rooftop Inlet Vent). 1. Net free area: 6.75 sq in per lin ft (14289 sq mm/m). 2. Dimensions: 11 inches (279 mm) wide by 48 inches (1220 mm) long by 1 inch (25 mm) high 3. Color: Black. S. Siding Vents: SV-3. 1. Net free area: 5 sq in per lin ft (10585 sq mm/m). 2. Dimensions: 7/16 inches (10.5mm) wide by 48 inches (1220 mm) long by 3 inch (75 mm) high. 3. Color: Black. T. U. Siding Vents: SV-5. 1. Net free area: 8.75 sq in per lin ft (17994 sq mm/m). 2. Dimensions: 3/4 inches (18.75mm) wide by 48 inches (1220 mm) long by 3 inch (75 mm) high. 3. Color: Black. U. Siding Vents: SS-112 Sturdi Strips. 1. Dimensions: 3/8 inches (9.65mm) depth by 1-1/2 inches (38 mm) wide by 48 inches (1220) long. 2. Color: Black. V. Siding Starter Strip: ST-30 Sturdi Starter. 1. Dimensions: 5/16 inches (7.87mm) wide by 1 1/4 inches (31.75 mm) tall by 48 inches (1220) long. 2. Color: Black. PART 3 EXECUTION 3.1 EXAMINATION A. Verify that framing, sheathing, and shingles are secured and ready to receive vents. B. Verify that there is a 1 inch (25 mm) wide clear air space between sheathing and each side of ridge board or, if trusses are used, a 1-1/2 inches (40 mm) wide continuous clear air space centered on ridge. 3.2 INSTALLATION A. General: ** NOTE TO SPECIFIER ** Vents should ordinarily be installed at each of the following locations. Edit as necessary to describe project conditions. 1. Install ridge vents along entire length of roof ridges. 2. Install soffit vents along entire length of soffits. 3. Install Roof-2-Wall vent along entire length of intersection of vertical walls. ** NOTE TO SPECIFIER ** Vents along hips are used only when the ridge vents would not provide adequate venting. Delete the following paragraph if hip vents are unnecessary.